Reference Guide

Access Control Lists (ACL) | 185
clear counters ip access-group
c e s
Erase all counters maintained for access lists.
Syntax
clear counters ip access-group [access-list-name]
Parameters
Command Modes
EXEC Privilege
Command
History
ip access-group
c e s
Assign an IP access list (IP ACL) to an interface.
Syntax
ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-id]
Parameters
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0,
names are up to 16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.2.1.1 Introduced
access-list-name
(OPTIONAL) Enter the name of a configured access-list, up to 140
characters.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0,
names are up to 16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.2.1.1 Introduced
access-list-name
Enter the name of a configured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming traffic.
out
Enter the keyword out to apply the ACL to outgoing traffic.
Note: Available only on 12-port 1-Gigabit Ethernet FLEX line card. Refer
to your line card documentation for specifications. Not available on
S-Series.
implicit-permit
(OPTIONAL) Enter the keyword implicit-permit to change the default
action of the ACL from implicit-deny to implicit-permit (that is, if the
traffic does not match the filters in the ACL, the traffic is permitted
instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the ID numbers of the
VLANs.
Range: 1 to 4094, 1-2094 for ExaScale (can used IDs 1-4094)