Reference Guide
1504 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
vrrp-ipv6-group
e c s
Assign an interface to a VRRP group.
Syntax
vrrp-ipv6-group vrid
Parameters
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a link-local virtual IP
address is configured. When you delete the virtual address, the VRRP group stops sending
VRRP packets.
E-Series ExaScale and TeraScale only: Starting in release 8.4.2.1, you can configure up to
255 VRRP groups per interface if VRF microcode is not loaded, and up to 15 groups if VRF
microcode is loaded.
E-Series ExaScale and TeraScale only: Starting in release 8.4.2.1, the VRID used by the
VRRP protocol changes according to whether VRF microcode is loaded or not:
• When VRF microcode is not loaded in CAM, the VRID for a VRRP group is the
same as the VRID number configured with the vrrp-group or vrrp-ipv6-group
command.
• When VRF microcode is loaded in CAM, the VRID for a VRRP group is equal to
16 times the vrrp-group or vrrp-ipv6-group vrid number plus the ip vrf vrf-id
number.
For example, if VRF microcode is loaded and VRRP group 10 is configured in VRF 2, the
VRID used for the VRRP group is (16 x 10) + 2, or 162. This VRID value is used in the lowest
byte of the virtual MAC address of the VRRP group and is also used for VRF routing.
Important: You must configure the same VRID on neighboring routers (Dell Force10 or
non-Dell Force10) in the same VRRP group in order for all routers to interoperate.
Related
Commands
vrid Enter the virtual-router ID number of the VRRP group.
VRID range (C-Series and S-Series): 1-255.
VRID range (E-Series): 1-255 when VRF microcode is not loaded and 1-15 when
VRF microcode is loaded.
Version 8.4.2.1 The range of valid VRID values on the E-Series when VRF microcode is
loaded in CAM changed to 1-15.
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series.
Version 8.3.7.0 Introduced on S4810
Version 8.3.2.0 Introduced on E-Series TeraScale
virtual-address Assign up to 12 virtual IP addresses per VRRP group.