Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 1499
Usage
Information
This command applies to a single interface.When used in conjunction with the vrrp delay reload
CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the
vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for vrrp.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
Related
Commands
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Syntax
vrrp delay minimum seconds
Parameters
Defaults
0
Command Modes
INTERFACE
Command
History
Usage
Information
This command applies to a all the VRRP configured interfaces on a system. When used in
conjunction with the vrrp delay minimum CLI, the later timer rules the VRRP enabling. For
example, if vrrp delay reload is 600 and the vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for vrrp.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
You must save the configuration and reload the system for the delay timers to take affect.
Related
Commands
vrrp-group
c e s
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
vrrp delay reload Set the delay time for VRRP initialization after a system reboot.
seconds
Enter the number of seconds for the delay.
Range: 0 to 900 (0 indicates no delay)
Version 8.3.8.0 Introduced on S4810
vrrp delay minimum Set the delay time for VRRP initialization after a line card reboot.