Reference Guide

Virtual Link Trunking (VLT) | 1477
clear vlt statistics
Clear the statistics on VLT operations.
Syntax
clear vlt statistics
Command Modes
EXEC
Command
History
Related
Commands
delay-restore
Configure the delay in bringing up VLT ports after reload or peer-link restoration between the
VLT peer switches.
Syntax
delay-restore
Parameters
Defaults
Not configured.
Command Modes
VLT DOMAIN
Command
History
Usage
Information
Use the delay-restore parameter to delay the system from bringing up the VLT port for a brief
period to allow IGMP Snooping and Layer 3 routing protocols to converge. This feature can
be used:
• after a VLT device is reloaded.
• if the Peer VLT device was up at the time the VLTi link failed to the time when it
was restored.
lacp ungroup member-independent
Enable BMP boot for the device connected to the LACP LAG or by a VLT peer device.
Syntax
lacp ungroup member-independent {vlt | port-channel port-channel-id}
Version 8.3.12.0 Introduced on S4810
show vlt statistics Display statistics on VLT operations.
delay-restore
Enter the amount of time, in seconds, to delay bringing up the VLT ports after
the VLTi device is reloaded or after the peer-link is restored between VLT
peer switches.
Range: 1 to 1200.
Default: 90 seconds.
Version 8.3.12.0 Introduced on S4810