Reference Guide

1406 | S-Series Stacking Commands
www.dell.com | support.dell.com
Related
Commands
stack-unit stack-group
Configure the stacking unit and stacking group by specifying an ID when adding units to a
stack to ensure the unit is assigned to the correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
Use no stack-unit unit-id stack-group stack-id to remove the current stack group configuration.
Parameters
Defaults
None
Command Mode
CONFIGURATION
Command
History
Usage
Information
The following message displays to confirm the command.
upgrade system stack-unit (S-Series stack member)
s
Copy the boot image or FTOS from the management unit to one or more stack members.
Syntax
upgrade {boot | system} stack-unit {all | 0-11 | A | B}
reload Reboot FTOS.
reset stack-unit Reset the designated S-Series stack member.
show system (S-Series
and S4810)
Display the current status of all stack members or a specific member.
unit-id
Enter the stack unit ID.
stack-group-id
Enter the stack group ID.
Range is 0 to 15.
Version 8.3.12.0 Reset command mode from EXEC to CONFIGURATION.
Version 8.3.10.2 Introduced on S4810
Warning: Setting ports Fo 0/60 as stack group will make their
interface configs obsolete after a reload.[confirm yes/no]:
If “y” is entered, all non-default configurations on any member ports of the current stack group
will be removed when the unit is rebooted.
Note: Any scripts used to streamline the stacking configuration process must be
updated to reflect the Command Mode change from EXEC Privilege to
CONFIGURATION to allow the scripts to work correctly.