Reference Guide

1238 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Parameters
Defaults
weight
= 120
Command Modes
ROUTER RIP
Command
History
Related
Commands
distribute-list in
c e s
Configure a filter for incoming routing updates.
Syntax
distribute-list prefix-list-name in [interface]
To delete the filter, use the
no distribute-list prefix-list-name in command.
Parameters
Defaults
Not configured.
weight
Enter a number from 1 to 255 for the weight (for prioritization).
The default is 120.
ip-address
(OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the
host or network to receive the new distance metric.
mask
If you enter an IP address, you must also enter a mask for that IP address, in
either dotted decimal format or /prefix format (/x)
prefix-name
(OPTIONAL) Enter a configured prefix list name.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
default-metric Assign one distance metric to all routes learned using the redistribute
command.
prefix-list-name Enter the name of a configured prefix list.
interface
(OPTIONAL) Identifies the interface type slot/port as one of the following:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed
by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to
4094.