Reference Guide

PIM-Sparse Mode (PIM-SM) | 1137
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
ipv6 pim sparse-mode
e
Enable IPv6 PIM sparse mode on the interface.
Syntax
ipv6 pim sparse-mode
To disable IPv6 PIM sparse mode, enter no ipv6 pim sparse-mode.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
Usage
Information
The interface must be enabled (no shutdown command) and not have the switchport command
configured. Multicast must also be enabled globally. PIM is supported on the port-channel
interface.
ipv6 pim spt-threshold
e
Specifies when a PIM leaf router should join the shortest path tree.
Syntax
ipv6 pim spt-threshold {kbps | infinity}
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by
a number:
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to
4094.
priority-value (OPTIONAL) Enter a number as the priority of this RP Candidate, which is
included in the Candidate-RP-Advertisements.
Range: 0 (highest) to 255 (lowest)
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced