Reference Guide
1094 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
Related
Commands
show ip ospf interface
c e s
Display the OSPF interfaces configured. If OSPF is not enabled on the switch, no output is
generated.
Syntax
show ip ospf process-id interface [interface]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS>show ip ospf int
GigabitEthernet 13/17 is up, line protocol is up
Internet Address 192.168.1.2/30, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 192.168.253.2, Interface address 192.168.1.2
Backup Designated Router (ID) 192.168.253.1, Interface address 192.168.1.1
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:02
Neighbor Count is 1, Adjacent neighbor count is 1
show ip ospf database Displays OSPF database information.
process-id Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For the null interface, enter the keyword null followed by zero (0).
• For loopback interfaces, enter the keyword loopback followed by a number
from 0 to 16383.
• For Port Channel groups, enter the keyword port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1-255 for TeraScale
• For a SONET interface, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by the VLAN ID. The range is
from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed
by the slot/port information.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced process-id option, in support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series