Users Guide

Table 105. Conguring a Static Route
Task Command Syntax Command Mode
Congure a static route that points to a
management interface.
management route ip-address
mask managementethernet
ormanagement route ipv6-
address prefix-length
managementethernet
NOTE: You can also have the
management route to point to a
front-end port in case of the
management VRF. For example:
management route 2::/64 te 0/0.
CONFIGURATION
To congure a static entry in the IPv6 neighbor discovery, perform the following steps:
Table 106. Conguring a Static Entry in the IPv6 Neighbor Discovery
Task Command Syntax Command Mode
Congure a static neighbor.
ipv6 neighbor vrf management
1::1 tengigabitethernet 1/1
xx:xx:xx:xx:xx:xx
CONFIGURATION
Sample VRF Conguration
The following conguration illustrates a typical VRF set-up.
Figure 145. Setup OSPF and Static Routes
944
Virtual Routing and Forwarding (VRF)