Users Guide
The neighbor entries are typically learned by a node using neighbor solicitation (NS) and ND messages. These NS or neighbor
advertisement (NA) messages can be either destined to the VLT node or to any nodes on the same network as the VLT interface.
These learned neighbor entries are propagated to another VLT node so that the peer does not need to relearn the entries.
Working of IPv6 Peer Routing
When peer routing is enabled on VLT nodes, the MAC address of the peer VLT node is stored in the ternary content addressable
memory (TCAM) space table of a station. If the data trac destined to a VLT node, node1, reaches the other VLT node, node2,
owing to LAG-level hashing in the ToR switch, it is routed instead of forwarding the packet to node1. This processing occurs because
of the match or hit for the entry in the TCAM of the VLT node2. This section contains the following topics that describe the
operations and benets of IPv6 peer routing in VLT domains:
Synchronization of IPv6 ND Entries in a VLT Domain
Because the VLT nodes appear as a single unit, the ND entries learned via the VLT interface are expected to be the same on both
the VLT nodes. VLT V6 VLAN and neighbor discovery protocol monitor (NDPM) entries synchronization between VLT nodes is
performed.
The VLT-v6 VLAN information needs to be synchronized with peer VLT node. Therefore, both the VLT nodes are aware of the VLT
VLAN information associated with the peers. The CLI conguration and dynamic state changes of VLT v6 VLANs are notied to peer
VLT node. The ND entries are generally learned by a node from Neighbor Advertisements (NA). ND entries synchronization should be
happening on the following two scenarios:
When VLT has been congured and enabled on both VLT node1 and node2, any dynamically learned ND entry in VLT node1 should be
synchronized instantaneously to VLT node2 and vice-versa. The link-local address will also be synchronized if learned on VLT VLAN
interface
During failure cases, when a VLT node goes down and comes back up all the ND entries learned via VLT interface must be
synchronized to the peer VLT node
Synchronization of IPv6 ND Entries in a Non-VLT Domain
L3 VLT provides a higher resiliency at the Layer 3 forwarding level. Routed VLT enables you to replace VRRP with routed VLT to
route the trac from L2 access nodes. With ND synchronization, both the VLT nodes perform Layer 3 forwarding on behalf of each
other. Synchronization of NDPM entries learned on non-VLT interfaces between the non-VLT nodes.
In the present design the NDPM entries learned on non-VLT interfaces are synchronized with the peer VLT nodes in case the ND
entries are learned on spanned VLANs so that each node can do L3 forwarding on behalf of each other. Whenever a VLAN is
congured on VLT node, this information is communicated to the peer VLT node regardless of whether the VLAN congured is a VLT
or a non-VLT interface. If the VLAN operational state (OSTATE) is up, dynamically learned ND entry in VLT node1 is synchronized to
VLT node2.
Tunneling of IPv6 ND in a VLT Domain
Tunneling an NA packet from one VLT node to its peer is required because an NA may reach the wrong VLT node instead of arriving
at the destined VLT node. This may occur because of LAG hashing at the top of the rack (ToR) switch. The tunneled NA will carry
some control information along with it so that the appropriate VLT node can mimic the ingress port as the VLT interface rather than
pointing to VLT node’s interconnecting link (ICL link).
The overall tunneling process involves the VLT nodes that are connected from TOR through a LAG. The picture below is a basic VLT
setup, which describes the communication between VLT nodes to tunnel the NA from one VLT node to its peer.
NA messages can be sent in two types of scenarios:
• Sometimes NA messages are sent by a node when its link-layer address is changed. This NA message is sent as an unsolicited
NA to advertise its new address and the destination address eld is set to the link-local scope of all-nodes multicast address. This
unsolicited NA packet need not be tunneled.
932
Virtual Link Trunking (VLT)










