Users Guide
seq 5 permit ip 200.200.200.200 200.200.200.200 199.199.199.199 199.199.199.199
seq 10 redirect 1.1.1.2 tcp 234.224.234.234 255.234.234.234 222.222.222.222/24 eq 40
ack, Next-hop reachable
(via Te 2/1),
Applied interfaces:
Te 2/2
NOTE: If you apply the redirect-list to an interface, the output of the show ip redirect-list redirect-
list-name command displays reachability status for the specied next-hop.
Example: Showing CAM PBR Conguration
Dell#show cam pbr stack-unit 1 port-set 0
TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 - FIN
Cam Port VlanID Proto Tcp Src Dst SrcIp DstIp Next-hop Egress
Index Flag Port Port MAC Port
----------------------------------------------------------------------------------------
-------------------------
06080 0 N/A IP 0x0 0 0 200.200.200.200
200.200.200.200 199.199.199.199
199.199.199.199 N/A NA
06081 0 N/A TCP 0x10 0 40 234.234.234.234 255.234.234.234 222.222.222.222/24
00:00:00:00:00:09 8/1
Sample Conguration
The following conguration is an example for setting up a PBR. These are not comprehensive directions. They are intended to give
you a some guidance with typical congurations. You can copy and paste from these examples to your CLI. Be sure you make the
necessary changes to support your own IP addresses, interfaces, names, and so on.
Illustration of the conguration shown below.
The Redirect-List GOLD dened in this example creates the following rules:
• description Route Gold trac to the DS3
• seq 5 redirect 10.99.99.254 ip 192.168.1.0/24 any “ Redirect to next-hop router IP 10.99.99.254 any trac originating in
192.168.1.0/24”
• seq 10 redirect 10.99.99.254 ip 192.168.2.0/24 any “ Redirect to next-hop router IP 10.99.99.254 any trac originating in
192.168.2.0/24”
• seq 15 permit ip any
Policy-based Routing (PBR)
617