Users Guide

portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2. Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type slot/port[]
Dell(conf)#default interface tengigabitethernet 1/5
3. Verify the conguration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied congurations are removed and the interface is set to the factory default state.
Enabling a Physical Interface
After determining the type of physical interfaces available, to enable and congure the interfaces, enter INTERFACE mode by using
the interface interface command.
1. Enter the keyword interface then the type of interface and slot/port information.
CONFIGURATION mode
interface interface
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
2. Enable the interface.
INTERFACE mode
no shutdown
To conrm that the interface is enabled, use the show config command in INTERFACE mode. To leave INTERFACE mode, use
the
exit command or end command. You cannot delete a physical interface.
Physical Interfaces
The Management Ethernet interface is a single RJ-45 Fast Ethernet port on a switch.
The interface provides dedicated management access to the system.
Stack-unit interfaces support Layer 2 and Layer 3 trac over the 10-Gigabit Ethernet and 40-Gigabit Ethernet, 25–Gigabit Ethernet,
40–Gigabit Ethernet, 50–Gigabit Ethernet, and 100–Gigabit Ethernet interfaces. These interfaces can also become part of virtual
interfaces such as virtual local area networks (VLANs) or port channels.
For more information about VLANs, refer to Bulk Conguration. For more information on port channels, refer to Port Channel
Interfaces.
Dell Networking OS Behavior: The system uses a single MAC address for all physical interfaces.
366
Interfaces