Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4810P
111112113114115116117118119120
To reset the number of FP blocks to the default, use the no version of these commands. By default, zero groups are allocated for
the ACL in VCAP. ACL VLAN groups or CAM optimization is not enabled by default. You must also allocate the slices for CAM
optimization.
To display the number of FP blocks that is allocated for the dierent VLAN services, use the show cam-acl-vlan command.
After you congure the ACL VLAN groups, reboot the system to store the settings in nonvolatile storage. During CAM initialization,
the chassis manager reads the NVRAM and allocates the dynamic VCAP regions.
112
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)