Reference Guide

Configuration Fundamentals | 33
IP
IPv6
IP COMMUNITY-LIST
IP ACCESS-LIST
STANDARD ACCESS-LIST
EXTENDED ACCESS-LIST
LINE
AUXILLIARY
CONSOLE
VIRTUAL TERMINAL
MAC ACCESS-LIST
MONITOR SESSION
MULTIPLE SPANNING TREE
Per-VLAN SPANNING TREE
PREFIX-LIST
RAPID SPANNING TREE
REDIRECT
ROUTE-MAP
ROUTER BGP
ROUTER ISIS
ROUTER OSPF
ROUTER RIP
SPANNING TREE
TRACE-LIST
Navigating CLI Modes
The FTOS prompt changes to indicate the CLI mode. Table 2-2, "FTOS Command Modes," in
Configuration Fundamentals lists the CLI mode, its prompt, and information on how to access and exit this
CLI mode. You must move linearly through the command modes, with the exception of the
end command
which takes you directly to EXEC Privilege mode; the
exit command moves you up one command mode
level.
Note: Sub-CONFIGURATION modes all have the letters “conf” in the prompt with additional modifiers to
identify the mode and slot/port information. These are shown in Table 2-2, "FTOS Command Modes," in
Configuration Fundamentals.
Table 2-2. FTOS Command Modes
CLI Command Mode Prompt
Access Command
EXEC
FTOS>
Access the router through the console or Telnet.
EXEC Privilege
FTOS# • From EXEC mode, enter the command enable.
• From any other mode, use the command end.