Manualshelf

Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4810P
241242243244245246247248249250
244 | Bare Metal Provisioning 2.0
www.dell.com | support.dell.com
• If there is a mismatch, the switch applies the downloaded version and reloads.
*********VALID IMAGE***********
DOWNLOADED RELEASE HEADER :
Release Image Major Version : 8
Release Image Minor Version : 3
Release Image Main Version : 8
Release Image Patch Version : 33
FLASH RELEASE HEADER B :
Release Image Major Version : 8
Release Image Minor Version : 3
Release Image Main Version : 10
Release Image Patch Version : 1
00:04:05: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_DOWNLOAD: The FTOS image download is successful.
Erasing Sseries Primary Image, please wait
.................................................................................................
.........................................................................................................
.........................................................................................................
.........................................................................................................
.....................................................................00:09:50: %STKUNsyncing disks...
IT0-M:CP %CHMGR-1 5-RELOAD: User done
request to reload the chassis
rebooting
• If there is no version mismatch the switch downloads the configuration file.
00:03:27: %STKUNIT0-M:CP %JUMPSTART-5-CFG_APPLY: The downloaded config from dhcp server is being
applied
00:03:27: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE: DHCP RELEASE sent on Fo 0/56.
00:03:27: %STKUNIT0-M:CP %SYS-5-CONFIG_LOAD: Loading configuration file
c If the configuration file is downloaded from the server, any saved startup-configuration on the
flash is ignored. If no configuration file is downloaded from the server or the
config-download
parameter is disable, the startup-configuration file on the flash is loaded as in normal reload.
6. When the FTOS image and the configuration file have been downloaded, the IP address is released.
00:04:06: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE: DHCP RELEASE sent on Fo 0/56.
00:04:06: %STKUNIT0-M:CP %IFMGR-5-ASTATE_DN: Changed interface Admin state to down: Fo 0/56
7. The switch applies the configuration. The switch is now up and running. It can be managed as usual.