Users Guide

Example (Address-
Family_IPv6)
The bold section identies that Multi-Topology IS-IS is enabled in Transition mode.
Dell(conf-router_isis-af_ipv6)# show conf
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
show isis database
Display the IS-IS link state database.
S4810
Syntax
show isis [vrf vrf-name] database [level-1 | level-2] [local] [detail |
summary] [system-id] [lspid]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to display IS-IS
link state database corresponding to that VRF.
NOTE: If you do not specify this option, the IS-IS link state database
corresponding to the default VRF are displayed.
level-1 (OPTIONAL) Displays the Level 1 IS-IS link-state database.
level-2 (OPTIONAL) Displays the Level 2 IS-IS link-state database.
local (OPTIONAL) Displays local link-state database information.
detail (OPTIONAL) Displays the detailed link-state database information of each LSP
when specied. If not specied, a summary displays.
summary (OPTIONAL) Displays the summary of link-state database information when
specied.
lspid (OPTIONAL) Display only the specied LSP.
system-id (OPTIONAL) Displays the link-state database for system-id.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added supported for VRF. Introduced on the S6000-ON.
938
Intermediate System to Intermediate System (IS-IS)