Users Guide
Related Commands
• banner exec — enables the display of a text string when you enter EXEC mode.
• banner login — sets a banner to display after successful login to the system.
cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos
number l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos]
number ecfmacl number {fcoeacl number} {iscsioptacl {0|2}} {openflow {4|8}}
Parameters
default Use the default CAM prole settings and set the CAM as follows:
• L3 ACL (ipv4acl): 4
• L2 ACL(l2acl): 6
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 2
• L2 QoS (l2qos): 1
• OpenFlow: 0 (disabled)
• FCoE (fcoeacl): 0 (disabled)
• iSCSI Optimization (iscsioptacl): 0 (disabled)
Allocate space to each CAM region.
Enter the CAM prole name then the amount of CAM space to be allotted. The
total space allocated must equal 13. The ipv6acl range must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
•
4: Creates 242 entries for use by the OpenFlow controller (256 total entries
minus the 14 entries reserved for internal functionality)
• 8: Creates 498 entries for use by the OpenFlow controller (512 total entries
minus the 14 entries reserved for internal functionality)
Using the fcoe parameter, enter the number of FP groups to be allocated for
FCoE transit. Enter
1 – 6; maximum six groups. Each group has 128 entries,
creating a total of 768 possible entries for FCoE FP groups. The value given must
be an even number.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
92
Control and Monitoring