Users Guide

Usage Information
When the interface goes down, Dell Networking OS withdraws the route. The route is re-installed, by Dell
Networking OS, when the interface comes back up. When a recursive resolution is “broken,” Dell Networking
OS withdraws the route. The route is re-installed, by Dell Networking OS, when the recursive resolution is
satised.
After an IPv6 static route interface is created, if an IP address is not assigned to a peer interface, the peer
must be manually pinged to resolve the neighbor information.
You can specify a weight for an IPv4 or IPv6 static route. If the weight value of a path is 0, then that path is
not used for forwarding when weighted ECMP is in eect. Also, if a path corresponding to a static route
(destination) has a non-zero weight assigned to it and other paths do not have any weight congured, then
regular ECMP is used for forwarding.
You can specify the weight value only to destination address and not on the egress port.
A route is considered for weighted ECMP calculations only if each paths corresponding to that route is
congured with a weight.
Example
Dell(conf)# ipv6 route 44::/64 33::1 weight 100
Dell(conf)# ipv6 route 44::/64 33::2 weight 200
Dell(conf)# do show running-config | grep ipv6 route
Dell(conf)# ipv6 route vrf vrf_test 44::/64 33::1 weight 100
Dell(conf)# ipv6 route vrf vrf_test 44::/64 33::2 weight 200
Dell(conf)# do show running-config | grep ipv6 route vrf
Related Commands
• show ipv6 route — view the IPv6 congured routes.
ipv6 unicast-routing
Enable IPv6 unicast routing on the device.
S4810
Syntax
ipv6 unicast-routing
To disable unicast routing, use the no ipv6 unicast-routing command.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
IPv6 Basics
867