Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
maximum dynamic-routes-ipv6
Specify the maximum number of dynamic (protocol) IPv6 routes a VRF can have.
S4810
Syntax maximum dynamic-routes—ipv6 limit {warn-threshold threshold-value | warning-
only}
To remove the limit on the maximum number of IPv6 routes used, use the no maximum dynamic-
routes-ipv6 command.
Parameters
limit Maximum number of IPv6 routes allowed in a VRF. Valid range is from 1 to 8000 (or
maximum allowable for that platform if smaller value).
warning-threshold Warning threshold value is expressed as a percentage of the limit value. When the
number of IPv6 routes reaches the specied percentage of the limit, a warning
message is generated. Valid range is 1 to 100. When warn-threshold is used, once
the limit is reached, additional routes will not be allowed into the RTM ( route table
manager ) itself.
warning-only When the warning-only option is used, a syslog message will be thrown when
maximum number of dynamic IPv6 routes reaches the limit. Additional dynamic
IPv6 routes will still be allowed.
Defaults No limit is set on the maximum number of dynamic IPv6 routes for a VRF.
Command Modes
CONFIGURATION-VRF
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, and Z9500.
856
IPv6 Basics