Users Guide

Fields Description
Protocol States whether IP is enabled (up) or disabled (down) on the interface.
Example (Brief)
Dell# show ip interface brief
Interface IP-Address OK? Method Status Protocol
TenGigabitEthernet 1/0 unassigned NO Manual administratively down down
TenGigabitEthernet 1/1 unassigned NO Manual administratively down down
TenGigabitEthernet 1/2 unassigned YES Manual up up
TenGigabitEthernet 1/3 unassigned YES Manual up up
TenGigabitEthernet 1/4 unassigned YES Manual up up
TenGigabitEthernet 1/5 10.10.10.1 YES Manual up up
TenGigabitEthernet 1/6 unassigned NO Manual administratively down down
show ip management-route
View the IP addresses assigned to the Management interface.
S4810
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number of
active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes also.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
IPv4 Routing
831