Users Guide

• For sFlow collectors, enter the keyword sflow-collector.
• For SNMP (traps and MIB responses), enter the keywords snmp .
• For SSH, enter the keyword ssh .
• For Syslog, enter the keyword syslog.
• For TACACS, enter the keyword tacacs.
• For Telnet, enter the keyword telnet.
• For TFTP, enter the keyword tftp.
all Congure all applications.
Defaults None.
Command Modes EIS Mode (conf-mgmt-eis)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
application (for HTTP and ICMP)
Congure the management egress interface selection for HTTP and ICMP.
NOTE: Only the options that have been newly introduced are described here. For a complete description on all of the
keywords and variables that are available with this command, refer the respective Command Reference Guide of the
applicable platform of the Release 9.2(0.0) documentation set.
S4810
Syntax
application {all | application-type}
To remove a management application conguration, use the no application {all |
application-type} command.
Parameters
application-type Enter any of the following keywords:
• For HTTP, enter the keyword http.
• For ICMP, enter the keyword icmp.
all Congure all applications.
Defaults None.
Command Modes EIS Mode (conf-mgmt-eis)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Interfaces
747