Users Guide

Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP address to the Management
port, use the ip address command.
If your system has two RPMs installed, use the show redundancy command to display which RPM is the
Primary RPM.
Example
Dell(conf)# interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related Commands
• management route — congure a static route that points to the Management interface or a forwarding
router.
• speed (Management interface) — clear the FIB entries on a specied line card.
interface null
Congure a Null interface on the switch.
S4810
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not congured; number = 0
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Interfaces
699