Users Guide
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the S6000-ON.
9.4.(0.0) Added support for PBR and VRF.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Claried block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
Save the new CAM settings to the startup-cong (write-mem or copy run start) then reload the
system for the new settings to take eect.
The total amount of space allowed is 16 FP Blocks. System ow requires three blocks; these blocks cannot
be reallocated. Only 13 number of blocks can be congured by the user .
There can be only one odd number of Blocks in the CLI conguration; the other Blocks must be in factors of
2. For example, a CLI conguration of 5+4+2+1+1 Blocks is not supported; a conguration of 6+4+2+1 Blocks
is supported.
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any conguration changes that have
changed the NVRAM content, use the command reload conditional nvram-cfg-change.
478
Content Addressable Memory (CAM)