Users Guide

cam-acl (Conguration)
Select the default CAM allocation settings or recongure a new CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and Layer
3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet Connectivity Fault
Management (CFM) ACLs, OpenFlow, and Policy-based Routing (PBR).
S4810
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos
number l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos
number] ecfmacl number [nlbclusteracl number] ipv4pbr number }openflow
number | fcoe number} [iscsioptacl number] [vrfv4acl number]
Parameters
default Use the default CAM prole settings and set the CAM as follows:
• L2Acl : 6
• IPV4Acl : 4
• IPV6Acl : 0
• IPV4Qos : 2
• L2Qos : 1
• L2PT : 0
• IpMacAcl : 0
• VmanQos : 0
• VmanDualQos : 0
• EcfmAcl : 0
• nlbclusteracl: 0
• FcoeAcl : 0
• iscsiOptAcl : 0
• ipv4pbr : 0
• vrfv4Acl :0
• Openow : 0
• fedgovacl : 0
l2acl number Enter the keyword l2acl and then the number of l2acl blocks. The range is from 1
to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP blocks for IPv4. The
range is from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP blocks for IPv6. The
range is from 0 to 4.
ipv4qos number Enter the keyword ipv4qos and then the number of FP blocks for IPv4. The
range is from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks for l2 qos. The range
is from 1to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol
tunnelling. The range is from 0 to 1.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks for IP and MAC
ACL. The range is from 0 to 6.
476
Content Addressable Memory (CAM)