Users Guide
Version Description
9.0.2.0. Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information When you enable this command, if a Policy Map containing classication rules (ACL and/or dscp/ ip-
precedence rules) is applied to more than one physical interface on the same port pipe, only a single copy of
the policy is written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of
interfaces. For more information, refer to the “IP Access Control Lists”, “Prex Lists”, and “Route-
map” sections in the
Dell Networking OS Conguration Guide
.
cam-acl-egress
Allocate CAM for egress ACLs.
S4810
Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl number
Parameters
default Reset egress CAM ACL entries to default settings.
l2acl number Allocate space to each CAM region. The total space allocated must equal 4. The
ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Content Addressable Memory (CAM)
475