Users Guide

Usage Information
This command enables sender-side-loopdetect for a specied BGP neighbor. BGP does not advertise a
route to a peer if the AS-Path of the route already contains the peer's AS.
NOTE: If you congure a neighbor to accept such routes using the neighbor allowas-in
command, you must disable sender-side loop detection for that neighbor.
Related Commands
• bgp client-to-client reection — enable route reection between the route reector and the clients.
neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all routes with that
attribute belong to the same community grouping.
S4810
Syntax
neighbor {ip-address | peer-group-name} send-community [extended |
standard]
To disable sending a COMMUNITY attribute, use the no neighbor {ip-address | peer-group-
name} send-community command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to send a COMMUNITY attribute to all routers
within the peer group.
extended (OPTIONAL) Enter the keyword extended to send extended community
attribute.
standard (OPTIONAL) Enter the keyword standard to send standard community attribute.
Defaults Not congured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information To congure a COMMUNITY attribute, use the set community command in ROUTE-MAP mode.
410
Border Gateway Protocol