Users Guide

To associate an access-list to a non-default VRF, use the vrf attribute of this command. You can use this
command at the interface context (physical/LAG) to apply the access-list to a range of VRFs.
The VRF MODE is not available for the default and management VRFs.
Related Commands
• ip access-list standard — congure a standard ACL.
• ip access-list extended — congure an extended ACL.
ip control-plane egress-lter
Enable egress Layer 3 ACL lookup for IPv4 CPU trac.
Syntax
ip control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
show ip accounting access-list
Display the IP access-lists created on the switch and the sequence of lters.
Syntax
show ip accounting {access-list access-list-name | cam_count} interface
interface [vrf vrf-name]
Parameters
access-list-name Enter the name of the ACL to be displayed.
cam_count List the count of the CAM rules for this ACL.
interface interface Enter the keyword interface then the one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number.
Access Control Lists (ACL)
207