Users Guide

show vrrp ipv6
View the active IPv6 VRRP groups. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP group.
Syntax
show vrrp ipv6 [vrid] [interface] [brief] [vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the virtual router identier for the VRRP group to view only
that group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE, and then
the slot/port information.
•
For a port channel interface, enter the keywords port-channel, and then a
number.
• For a VLAN interface, enter the keyword vlan, and then a number from 1 to
4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the
VRRP groups.
vrf vrf-name Enter the keyword vrf then the name of the VRF to view IPv6 VRRP groups
corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series.
Usage Information The following describes the show vrrp ipv6 command.
Line starting
with
Description
GigabitEthernet... Displays the interface, VRRP group ID, and network address. If the interface is not
sending VRRP packets, 0.0.0.0 appears as the network IP address.
VRF VRF instance to which the VRRP group interface belongs.
State: master... Displays the interface’s state:
1694
Virtual Router Redundancy Protocol (VRRP)