Users Guide

• When an interface comes up, whether as part of a system reload or an interface reload, the system waits
300 seconds (5 minutes) to bring up VRRP on that interface.
For the delay timers to take eect, save the conguration and reload the system.
Related Command
• vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.
vrrp-group
Assign a VRRP ID to an interface. You can congure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
The VRRP group only becomes active and sends VRRP packets when you congure a virtual IP address.
When you delete the virtual IP address, the VRRP group stops sending VRRP packets.
Related Command
• virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
version
Set the VRRP protocol version for the IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
1690
Virtual Router Redundancy Protocol (VRRP)