Users Guide

priority
Specify a VRRP priority value for the VRRP group. The VRRP protocol uses this value during the MASTER election process.
Syntax
priority priority
To return to the default value, use the no priority command.
Parameters
priority Enter a number as the priority. Enter 255 only if the router’s virtual address is the
same as the interface’s primary IP address (that is, the router is the OWNER). The
range is from 1 to 255. The default is 100.
Defaults 100
Command Modes VRRP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.16.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
To guarantee that a VRRP group becomes MASTER, congure the VRRP group’s virtual address with same
IP address as the interface’s primary IP address and change the priority of the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal to the interface’s
primary IP address, an error message appears.
show cong
View the nondefault VRRP conguration.
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all the VRRP group
conguration information, including default information.
Command Modes VRRP
1682
Virtual Router Redundancy Protocol (VRRP)