Users Guide

Version Description
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information You can congure both IPv4 and IPv6 virtual addresses simultaneously, but only one of each. Each time this
command is issued, it replaces the previously congured address of the same family, IPv4 or IPv6. The no
virtual-ip command takes an address/prex-length argument, so that the desired address only is
removed. If you enter the
no virtual-ip command without any specied address, then both IPv4 and
IPv6 virtual addresses are removed.
Related Commands
• ip address — assigns a primary and secondary IP address to the interface.
write
Copy the current conguration to either the startup-conguration le or the terminal.
Syntax
write {memory compressed| terminal}
Parameters
memory Enter the keyword memory to copy the current running conguration to the
startup conguration le. This command is similar to the copy running-
config startup-config
command.
compressed Enter the keyword compressed to write the operating conguration to the
startup-cong le in the compressed mode.
terminal Enter the keyword terminal to copy the current running conguration to the
terminal. This command is similar to the show running-config command.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
164
Control and Monitoring