Users Guide

dei mark
Set the DEI value on egress according to the color currently assigned to the packet.
S4810
Syntax
dei mark {green | yellow} {0 | 1}
Parameters
0 | 1 Enter the bit value you want to map to a color.
green | red | yellow Choose a color:
• Green: High priority packets that are the least preferred to be dropped.
• Yellow: Lower priority packets that are treated as best-eort.
Defaults All the packets on egress are marked with DEI 0.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
Usage Information Enable DEI before using this command.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in
its conguration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel, and then a
number.
1626
VLAN Stacking