Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4810P

1601

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.9(0.0) Introduced on the C9010.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.3(0.0) Introduced on the S6000, S4810, S4820T, Z9000.

Usage Information

This command congures the method used to set the high 6 bits (the dierentiated services codepoint) of

the IPv4 TOS or the IPv6 trac class in the outer IP header.

A value of 0 copies original packet DSCP (IPv4)/Trac Class (IPv6) to the tunnel header DSCP (IPv4)/

Trac Class (IPv6) depending on the mode of tunnel.

tunnel ow-label

Congure the method to set the IPv6 ow label value in the outer tunnel header.

Syntax

tunnel flow-label value

To return to the default value of 0, use the no tunnel flow-label value command.

Parameters

value Enter a value to set the IPv6 ow label value in the tunnel header. The range is

from 0 to 1048575. The default value is 0.

Defaults 0 (Mapped original packet ow-label value to tunnel header ow-label value)

Command Modes INTERFACE TUNNEL (conf-if-tu)