Users Guide
Version Description
9.10(0.0) Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000,
S6000–ON, Z9500, MXL.
Usage Information This command is optional for SupportAssist service conguration.
SupportAssist Server Commands
Dell Networking OS supports the following SupportAssist Server mode commands.
proxy-ip-address
Congure a proxy for reaching the SupportAssist remote server.
Syntax
proxy-ip-address {ipv4-address | ipv6-address} port port-number [ username
userid password [encryption-type] password ]
To remove the proxy, use the no proxy-ip-address command.
Parameters
ipv4-address Enter the IP address of the proxy server in a dotted decimal format (A.B.C.D).
ipv6-address Enter the IPv6 address of the proxy server in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
NOTE: To use the IPv6 address, the Open Automation package should also
support IPv6 communications. For this purpose, SupportAssist requires
Dell Networking Open Automation 9.10(0.0) package or later.
port port-number Enter the keyword port then the TCP/IP port number. The port number range is
from 80 to 100000.
username userid (OPTIONAL) Enter the keyword username then the user ID used for the proxy
server.
password Enter the keyword password then the encryption-type or the user password.
encryption-type (OPTIONAL) Enter an encryption type for the password you enter.
• 0 directs the system to interpret the password as clear text.
• 7 indicates that the password is encrypted using a DES hashing algorithm.
password Enter a string up to 32 characters long.
Defaults encryption-type for the password is 0.
Command Modes SUPPORTASSIST SERVER
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
1578
SupportAssist