Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810
8.5.1.0 Added support for 4-port 40G line cards.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information To enable this snmp-server trap-source command, congure an IP address on the interface and
enable the interface congured as an SNMP trap source.
Related Commands
• snmp-server community — sets the community string.
snmp-server user
Congure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-name udp-port
port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password]
[priv {des56 | aes128} priv password] [access access-list-name | ipv6
access-list-name | access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name
remote ip-address vrf vrf-name udp-port port-number} [1 | 2c | 3]
[encrypted] [auth {md5 | sha} auth-password] [priv {des56 | aes128} priv
password] [access access-list-name | ipv6 access-list-name | access-list-
name ipv6 access-list-name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that
connects to the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group. The
following groups are created for mapping to read/write community/security-names
(defaults):
• v1v2creadu — maps to a community with ro permissions.
• 1v2cwriteu — maps to a community rw permissions.
remote ip-address Enter the keywords udp-port then the user datagram protocol (UDP) port
number on the remote device. The range is from 0 to 65535. The default is 162.
vrf vrf-name Enter the keywords vrf and then the name of the VRF this is used to connect to
the SNMP server.
NOTE: Use this attribute to specify a VRF name that is used to connect to
the remote host. If no VRF is specied, then the default VRF is used.
1498
Simple Network Management Protocol (SNMP) and Syslog