Users Guide

• supply
• temperature
For the snmp notication-type, enter one of the following optional parameters:
• authentication
• coldstart
• linkdown
• linkup
• syslog-reachable
• syslog-unreachable
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the following two SNMP notication options: syslog-reachable and
syslog-unreachable.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for copy-cong and ECMP traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information
Dell Networking OS supports up to 16 SNMP trap receivers.
For the cam-utilization notication option, the system generates syslogs and SNMP traps when the
L3 host table or route table utilization goes above the threshold.
Simple Network Management Protocol (SNMP) and Syslog
1489