Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4810P
1331133213331334133513361337133813391340
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information
When a neighbor router is identied, unicast data exchanges occur. Multiple neighbor routers are possible.
To ensure that only specic interfaces are receiving and sending data, use the passive-interface
command with the neighbor command.
Related Commands
• passive-interface — sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specied network. To enable RIP on all networks connected to the switch, use this command.
S4810
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address Specify an IP network address in dotted decimal format. You cannot specify a
subnet.
Defaults No RIP network is congured.
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
Routing Information Protocol (RIP)
1333