Users Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Added support for the ipv6 and ip-any options on the Z9000, S6000, S4820T,
S4810, MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added the keyword multicast . Added support for the DSCP Marking option for the
S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series. Added support for the DSCP Marking option.
6.1.1.1 Introduced on the E-Series.
Usage Information
To access this command, enter the class-map command. After the class map is identied, you can
congure the match criteria.
The match ip precedence command and the match ip dscp command are mutually exclusive.
Up to eight precedence values can be matched in one match statement. For example, to indicate the IP
precedence values 0 1 2 3, enter either the match ip precedence 0-3 or match ip precedence
0,1,2,3 command.
NOTE: Only one of the IP precedence values must be a successful match criterion, not all of the
specied IP precedence values must match.
Related Commands
• class-map — identies the class map.
match ip vlan
Uses a VLAN as the match criterion for an L3 class map.
S4810
Syntax
match ip vlan vlan-idTo remove VLAN as the match criterion, use the no match ip vlan
vlan-id command.
Parameters
vlan vlan-id Enter the keyword vlan and then the ID of the VLAN. The range is from 1 to 4094.
Defaults None.
Command Modes CONF-CLASS-MAP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
1282
Quality of Service (QoS)