Users Guide

show ip pim interface
View information on the interfaces with IP PIM enabled.
S4810
Syntax
show ip pim [vrf vrf-name] interface
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to
congure this setting on this VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip pim interface command shown in the following example.
Field Description
Address Lists the IP addresses of the interfaces participating in PIM.
Interface List the interface type, with either slot/port information or ID (VLAN or Port
Channel), of the interfaces participating in PIM.
Ver/Mode Displays the PIM version number and mode for each interface participating in PIM:
• v2 = PIM version 2
• S = PIM Sparse mode
Nbr Count Displays the number of PIM neighbors discovered over this interface.
Query Intvl Displays the query interval for Router Query messages on that interface
(congured with ip pim query-interval command).
1226
PIM-Sparse Mode (PIM-SM)