Users Guide

However, if you congure ip pim ssm-range {access list name} rst and then you congure
the ACL as an Extended ACL, an error is not reported and the ACL is not applied to the SSM range.
Dell Networking OS-recommended best-practices are to congure the standard ACL, and then apply the
ACL to the SSM range. After the SSM range is applied, the changes are applied internally without requiring
clearing of the tree information base (TIB).
When the ACL rules change, the ACL and protocol-independent multicast (PIM) modules apply the new
rules automatically.
When you congure the SSM range, Dell Networking OS supports SSM for congured group range as well
as the default SSM range.
When you remove the SSM ACL, PIM SSM is supported for the default SSM range only.
ip pim spt-threshold
To switch to the shortest path tree when the trac reaches the specied threshold value, congure the PIM router.
S4810
Syntax
ip pim [vrf vrf-name] spt-threshold [value | infinity]
To return to the default value, use the no ip pim [vrf vrf-name] spt-threshold
[infinity] command.
Parameters
value (OPTIONAL) Enter the trac value in kilobits per second. The default is 10 packets
per second . A value of zero (0) causes a switchover on the rst packet.
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to
congure the PIM router on that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
innity (OPTIONAL) Enter the keyword infinity to never switch to the source-tree.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
PIM-Sparse Mode (PIM-SM)
1223