Users Guide
• ack = acknowledgement
• fin = nish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent eld
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prex format (/x).
any Enter the keyword any to specify that all trac is subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
•
gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for theport
command parameter.)
Defaults None
Command Modes REDIRECT-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Added support for the track-id on the S4810, S4820T, S6000, and Z9000.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.7.1.0 Introduced on the E-Series.
Policy-based Routing (PBR)
1203