Reference Guide

Link Layer Discovery Protocol (LLDP) | 961
hello
c e s
Configure the rate at which the LLDP control packets are sent to its peer.
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
Defaults
30 seconds
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
mode
c e s
Set LLDP to receive or transmit.
Syntax
mode
{tx | rx}
To return to the default, use the
no mode {tx | rx} command.
Parameters
Defaults
Both transmit and receive
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
seconds
Enter the rate, in seconds, at which the control packets are sent to its peer.
Rate: 5 to 180 seconds
Default: 30 seconds
Version 8.3.7.0 Introduced on S4810
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
tx
Enter the keyword tx to set the mode to transmit.
rx
Enter the keyword rx to set the mode to receive.
Version 8.3.7.0 Introduced on S4810
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series