Reference Guide

938 | Layer 2
www.dell.com | support.dell.com
Command Modes
CONFIGURATION
Command
History
Usage
Information
no default vlan disable is not listed in the running-configuration, but when the default VLAN
is disabled,
default-vlan disable is listed in the running-configuration.
enable vlan-counters
e
x
Display VLAN counters for ingress and/or egress hardware. You must be in restricted mode
to use this command.
Syntax
enable vlan-output-counters [ingress | egress | all]
To return to the default (disabled), use the no enable vlan-output-counters command.
Defaults
Disabled — VLAN counters are disabled in hardware (all linecards/port-pipes) by default.
Command Modes
CONFIGURATION
Command
History
Example
FTOS(conf)#enable vlan-output-counters
FTOS(conf)#exit
FTOS#show interface vlan 101
Vlan 101 is down, line protocol is down
Address is 00:01:e8:26:e0:5b, Current address is 00:01:e8:26:e0:5b
Interface index is 1107787877
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 01:12:44
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
Output Statistics:
0 packets, 0 bytes
Time since last interface status change: 01:12:44
FTOS#
FTOS#show interfaces vlan 1
Vlan 1 is down, line protocol is down
Address is 00:01:e8:13:a5:aa, Current address is 00:01:e8:13:a5:aa
Interface index is 1107787777
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 01:36:01
Queueing strategy: fifo
Input Statistics:
Version 8.3.7.0 Introduced no S4810
Version 8.3.1.0 Introduced
Version 8.1.1.2 Introduced on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale E1200i