Reference Guide

918 | Layer 2
www.dell.com | support.dell.com
Command Modes
CONFIGURATION
INTERFACE VLAN (E-Series only)
Command
History
Related
Commands
mac-address-table static
c e s
Associate specific MAC or hardware addresses to an interface and VLANs.
Syntax
mac-address-table static mac-address output interface vlan vlan-id
To remove a MAC address, use the no mac-address-table static mac-address output interface
vlan
vlan-id command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Version 8.3.7.0 Introduced on S4810
Version 8.3.1.0 On the E-Series, available in INTERFACE VLAN context and reduced
minimum aging time in INTERFACE VLAN context from 10 seconds
to 1 second.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
mac learning-limit Set the MAC address learning limits for a selected interface.
show mac-address-table aging-time Display the MAC aging time.
mac-address
Enter the 48-bit hexidecimal address in nn:nn:nn:nn:nn:nn format.
output interface Enter the keyword output followed by one of the following
interfaces:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel
followed by a number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword sonet followed by the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
followed by the slot/port information.
vlan vlan-id Enter the keyword vlan followed by a VLAN ID.
Range:1 to 4094.