Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 839
Command
History
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of
the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in
the Route map used in this command. If you identify a peer by IP address, the Route map
overwrites either the inbound or outbound policies on that peer.
neighbor route-reflector-client
c e
Configure a neighbor as a member of a route reflector cluster.
Syntax
neighbor ipv6-address| peer-group-name route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector
configuration, use the
no neighbor ipv6-address | peer-group-name route-reflector-client
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
The first time you enter this command it configures the neighbor as a route reflector and
members of the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully
meshed if you configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.
network
c e
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ipv6-address [route-map map-name]
To remove a network, use the
no network ipv6-address [route-map map-name] command.
Version 8.4.2.1 Introduced on C-Series and S4810
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format.
The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name (OPTIONAL) Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Version 8.4.2.1 Introduced on C-Series and S4810
Version 7.4.1.0 Introduced on E-Series TeraScale