Reference Guide

778 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Command
History
Related
Commands
capture bgp-pdu max-buffer-size
c e
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6
addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
Defaults
40960000 bytes
Command Modes
EXEC
EXEC Privilege
Command
History
Related
Commands
clear ip bgp * (asterisk)
c e
Reset all BGP sessions in the specified category on the E-Series. The soft parameter (BGP
Soft Reconfiguration) clears the policies without resetting the TCP connection.
Syntax
clear ip bgp * [ipv4 multicast soft [in | out] | ipv6 unicast soft [in | out] | soft [in | out]]
Parameters
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
capture bgp-pdu max-buffer-size Enable route reflection between route reflector and clients.
show capture bgp-pdu neighbor Configure a route reflector and clients.
capture bgp-pdu neighbor Enable capture of an IPv4 BGP neighbor packet.
100-102400000
Enter a size for the capture buffer.
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
capture bgp-pdu neighbor (ipv6) Enable capture of an IPv6 BGP neighbor packet.
show capture bgp-pdu neighbor Configure a route reflector and clients.
*
Enter an asterisk ( * ) to reset all BGP sessions.
ipv4 multicast soft [in | out]
(OPTIONAL) This keyword sequence sets options within the
a specified IPv4 address family.
ipv6 unicast soft [in | out]
(OPTIONAL) This keyword sequence sets options within the
a specified IPv6 address family.