Reference Guide

754 | IPv6 Basics
www.dell.com | support.dell.com
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword Loopback followed
by a number from 0 to 16383.
• For the Null interface, enter the keyword
null followed by zero
(0).
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
followed by the slot/port information.
• For a VLAN interface, enter the keyword
VLAN.
• For a port channel interface, enter the keyword port-channel.
brief
(OPTIONAL) View a summary of IPv6 interfaces.
configured
(OPTIONAL) View information on all IPv6 configured interfaces
gigabitethernet
(OPTIONAL) View information for an IPv6 gigabitethernet
interface.
linecard slot-number (OPTIONAL) View information for a specific IPv6 linecard or
S-Series stack-unit
Range: 0 to 13 on a E1200, 0 to 6 on a E600, and 0 to 5 on a E300.
Range: 0 to 7 for C-Series
Range: 0 to 7 for S55 only
Range: 0 to 11 for S60 and S4810
managementethernet slot/
port
(OPTIONAL) View information on an IPv6 Management port.
Enter the slot number (0-1) and port number zero (0).
loopback
(OPTIONAL) View information for IPv6 loopback interfaces.
port-channel
(OPTIONAL) View information for IPv6 port channels.
tengigabitethernet
(OPTIONAL) View information for an IPv6 tengigabitethernet
interface.
fortyGigE
(OPTIONAL) View information for an IPv6 fortygigabitethernet
interface.
vlan
(OPTIONAL) View information for IPv6 VLANs.
Version 8.3.7.0 Introduced on the S4810
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.4.2.1 Introduced on S-Series
Version 8.2.1.0 Introduced on E-Series ExaScale.
Support for the managementethernet slot/port parameter was added.
Version 7.8.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series TeraScale