Reference Guide

IPv6 Basics | 747
gigabitethernet Gigabit Ethernet interface
loopback Loopback interface
null Null interface
port-channel Port channel interface
sonet Sonet interface
tenGigabitethernet TenGigabit Ethernet interface
vlan VLAN interface
FTOS(conf)#ipv6 route 55::0 /64 gigabitethernet 9/0 ?
<1-255> Distance metric for this route
X:X:X:X::X Forwarding router's address
permanent Permanent route
tag Set tag for this route
FTOS(conf)#ipv6 route 55::0 /64 gigabitethernet 9/0 66::1 ?
<1-255> Distance metric for this route
permanent Permanent route
tag Set tag for this route
FTOS#
Usage
Information
When the interface goes down, FTOS withdraws the route. The route is re-installed, by
FTOS, when the interface comes back up. When a recursive resolution is “broken,” FTOS
withdraws the route. The route is re-installed, by FTOS, when the recursive resolution is
satisfied.
After an IPv6 static route interface is created, if an IP address is not assigned to a peer
interface, the peer must be manually pinged to resolve the neighbor information.
Related
Commands
ipv6 unicast-routing
c e s
Enable IPv6 Unicast routing.
Syntax
ipv6 unicast-routing
To disable unicast routing, use the no ipv6 unicast-routing command.
Defaults
Enabled
Command Modes
CONFIGURATION
Command
History
show ipv6 route View the IPv6 configured routes.
Version 8.3.7.0 Introduced on the S4810
Version 8.4.2.1 Introduced on S-Series
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series TeraScale