Reference Guide

740 | IPv6 Basics
www.dell.com | support.dell.com
• show ipv6 interface
• show ipv6 mld_host
• show ipv6 route
• trust ipv6-diffserv
clear ipv6 fib
c e s
Clear (refresh) all FIB entries on a linecard or stack unit.
Syntax
clear ipv6 fib linecard slot | stack-unit unit-number
Parameters
Command Mode
EXEC Privilege
Command
History
clear ipv6 route
c e s
Clear (refresh) all or a specific route from the IPv6 routing table.
Syntax
clear ipv6 route {* | ipv6-address prefix-length}
Parameters
Command Mode
EXEC Privilege
Command
History
slot Enter the slot number to clear the FIB for a linecard.
unit-number Enter the stack member number.
Range: 0 to 7 for Z9000, 0-11 for S4810.
Version 8.3.7.0 Introduced on the S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.4.1.0 Introduced on E-Series TeraScale
*
Enter the * to clear (refresh) all routes from the IPv6 routing table.
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in
the /x format.
Range: /0 to /128
Note: The :: notation specifies successive hexadecimal fields of zeros
Version 8.3.7.0 Introduced on the S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.4.1.0 Introduced on E-Series TeraScale