Reference Guide

74 | Control and Monitoring
www.dell.com | support.dell.com
Command
History
do
c e s
Allows the execution of most EXEC-level commands from all CONFIGURATION levels
without returning to the EXEC level.
Syntax
do command
Parameters
Defaults
No default behavior
Command Modes
CONFIGURATION
INTERFACE
Command
History
Usage
Information
The following commands are not supported by the do command:
•
enable
•
disable
•
exit
•
config
Example
FTOS(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
FTOS(conf-if-te-5/0)#
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
command Enter an EXEC-level command.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced on E-Series